SignTorch
Artist
Remove the ground jumpers on BOB pins 10 and 11.
The X limit switch is an orange wire on pin 16 of the connector which goes to pin 11 on the BOB.
The Y limit switch is a blue wire on connector pin 15 which goes to pin 10 on the BOB.
Make the above connections then run Mach3 and press reset.
The lights for pins 10 and 11 on the BOB should be off.
When each limit switch is tripped, the corresponding light on the BOB should come on.
Note: at some point we will change this to have all limit switches wired in series on one input pin
The X limit switch is an orange wire on pin 16 of the connector which goes to pin 11 on the BOB.
The Y limit switch is a blue wire on connector pin 15 which goes to pin 10 on the BOB.
Make the above connections then run Mach3 and press reset.
The lights for pins 10 and 11 on the BOB should be off.
When each limit switch is tripped, the corresponding light on the BOB should come on.
Note: at some point we will change this to have all limit switches wired in series on one input pin